
All of Slovakia
Window film for schools and nurseries
In May, June and September classrooms get hot. Children struggle to focus and the board shines. Window film helps without building work. It can also make the glass safer.
- Solar and safety films
- Fitting in the holidays or afternoons
- Documents for public procurement
In short
Two types of film help schools most. Solar film reduces heat and glare in classrooms. Safety film holds the pieces together if the glass breaks, so there is less risk of cuts. Both go onto existing windows. We fit them in the holidays, in the afternoons or at weekends. We supply data sheets and documents for public procurement.
What window film does for you
-
Less heat in the room
Depending on film and glass, it stops 36 to 85 % of solar energy. Homes and offices stay cooler in summer.
-
Less glare
You can see your screen and TV even in the sun. No need to keep the blinds down all day.
-
UV protection
The film stops up to 99 % of UV radiation. Floors, furniture and shop-window goods fade much more slowly.
-
No new windows needed
We apply film to your existing glass. A flat or house usually takes one day, with no dust or building work.

Why classrooms get hot in summer
Classrooms have large windows to let in plenty of daylight. In the warm months, a lot of heat comes in too.
Many children sit in one classroom and each one adds heat. If the windows face south or west, the temperature climbs quickly.
External blinds would help, but fitting them to a school facade is costly and slow. Film goes straight onto the glass, with no work on the facade.
For school staff, the regulation on heat stress at work also applies. More on overheating offices and buildings.
Less glare on the board
Sun on a whiteboard, interactive board or screen makes it hard to read. Teachers then close the blinds and switch the lights on in daytime.
Film reduces glare without darkening the classroom. 3M Prestige 70 on double glazing lets through 63 % of light. Fitted inside it rejects 42 % of solar energy, outside 61 %.
For classrooms we recommend light films. That way children get enough daylight.
Safer glass
In corridors, gyms and entrances, glass can break on impact. Ordinary glass falls apart into sharp pieces.
Safety film holds the pieces together. It lowers the risk of cuts and makes it harder to get in through a broken window.
We choose safety film for schools by location. For glazed doors and corridors, EN 12600 is enough. Ground-floor windows get a thicker film rated to EN 356. On uPVC and aluminium windows we fit it under the glazing bead. More on safety film under the glazing bead.
Film strength is tested to EN 12600 (a pendulum impact test). For example, 3M S70 at 175 µm reaches class 2B2. More on safety window film.
Want both at once? 3M Ultra Prestige S70 combines safety and solar film.

Fitting in the holidays
- Summer holidays – the best time for large areas. The school is empty and we disturb no one.
- Afternoons and weekends – we fit smaller areas after lessons.
- No dust or drilling – the film is fitted wet.
- At height – we fit gyms and atriums from platforms. The team is always two fitters certified for work at height.
- Curing – don’t clean the glass for the first 30 days. Fit it in summer and the school is ready for September.
Nurseries
In nurseries, windows are often low and within children’s reach. Safety film makes a lot of sense here.
For windows facing the street, frosted film helps. It lets light in but not views from outside. More on frosted and decorative films.
In nap rooms a darker solar film can help. It reduces glare during the afternoon nap.
Procurement and budget
Schools usually buy through public procurement. We supply film data sheets with manufacturer values. We prepare the quote with an itemised breakdown.
On a tighter budget, it helps to split the work into stages. First the classrooms facing south and west, then the rest.
You see a guide price straight away in the form. Worked examples are on how much window film costs.
Experience in buildings in use
We have been fitting film for 25 years. We have also worked on Comenius University buildings while they were in use.
We have worked in busy shopping centres and in nuclear power plants. We know how to work safely and around daily operations.
Our approach for public buildings is on films for businesses and public buildings.
School problems and the right film
| Problem | Film | Where |
|---|---|---|
| Hot classroom | Light solar film, for example 3M Prestige 70 | Classrooms facing south and west |
| Glare on boards and screens | Low-reflection solar film | Classrooms and staff rooms |
| Risk of cuts from glass | Clear safety film (EN 12600) | Corridors, entrances, gyms, low windows |
| Broken windows and break-ins | Thicker 3M safety film | Ground floor, offices, storerooms |
| Views from the street | Frosted or decorative film | Nurseries, changing rooms, toilets |
| Heat and safety together | 3M Ultra Prestige S70 | Large ground-floor glazing |
We choose the specific film after a site visit, based on the glass and window direction.
Preparing for the installation
Film is applied wet, so the fitter needs to reach the glass from the front and the sides with a squeegee, knife and sprayer.
Caring for window film
Do not clean the film for the first 30 days. A light haze and small water bubbles are normal. They disappear on their own as the film dries. In winter this takes longer.
Do
- Plenty of water with a drop of mild detergent (no ammonia)
- Soft microfibre cloth
- Rubber squeegee for the remaining water
- Clean exterior film just as gently as interior film
Don’t
- Razor blades, scrapers and rough sponges
- Cleaners with ammonia or grit
- Stickers, tape and suction cups on the film
- A pressure washer close to the edges of exterior film
Tip from practice: When you clean the frames, take care of the film edges. Do not lift them with a fingernail or cloth.
Full film care guideUpdated: November 2026
Why choose us to fit your film
We are a certified 3M Endorsed Installer. Our fitters were trained and tested by 3M itself. We have been fitting window and car films for 25 years. How long a film lasts depends on how well it is fitted.
We have even worked inside nuclear power plants
We fitted film at the Jaslovské Bohunice and Mochovce nuclear power plants. With security clearance, work permits and the strictest health and safety rules. We bring the same discipline to your flat or office.
Open shopping centres and work from platforms
Aupark, Eurovea and Polus did not close for us. We worked section by section and before opening. The work area was fenced off. We reached atriums and skylights from platforms. All our installers are certified for work at height and for operating aerial work platforms and walkways.
Only premium materials, data shown openly
We use only premium films from 3M, Avery Dennison, ORAFOL and Solar Screen. They last longer, keep their colour and carry a manufacturer warranty. For every film you get the data sheet and certificates. The values in our quote are the manufacturer’s figures to recognised standards. Not sales promises.
We tell you when film isn’t the answer
Sometimes film will not solve the problem. Or the glass could crack from uneven heat (thermal stress). Then we tell you plainly and suggest what to do instead.
How it works
From your first message to the finished job usually takes a few days. For buildings, we plan the work so it does not disrupt your operations.
Enquiry or photo
Fill in the online form and see an estimated price at the end. Or send a photo to m2s@m2s.sk. Rough sizes are enough.
Free site visit
For buildings, we visit, measure the windows and check the glass. Then we recommend a suitable film.
Your quote
We prepare it as soon as possible. It has a clear price, the exact material, a date and the warranty terms.
Installation and warranty
Our team of two installers fits the film. You get the data sheet, the manufacturer’s warranty terms and an invoice. For cars, also a certificate of installation.
Frequently asked questions
Didn’t find your answer? E-mail us or send a free quote request – advice costs nothing.
Send us an e-mailWhich film is best for a classroom?
Most often a light solar film such as 3M Prestige 70. It reduces heat and glare and the classroom stays bright. On double glazing we often choose the exterior version.
Will film make the classroom darker?
A light film hardly does. 3M Prestige 70 lets through 63 % of light on double glazing. The eye perceives the drop as smaller than the number suggests.
When is the best time to fit film in a school?
Ideally in the summer holidays. We also fit smaller areas in the afternoon or at weekends. Lessons don’t need to stop.
Is the film safe for children?
Yes. It is a thin film firmly bonded to the glass. Safety film for schools and nurseries also holds the pieces together if the glass breaks.
Will film protect a window from a ball?
Film doesn’t make glass unbreakable. But it holds the pieces together if it breaks. That greatly lowers the risk of cuts.
Can heat control and safety be combined?
Yes, with 3M Ultra Prestige S70. It is a safety film with solar control. On single glazing it rejects 49 % of solar energy.
Does film affect Wi-Fi in the school?
Metal-free films like 3M Prestige don’t block Wi-Fi or mobile signal. Only films with a metal layer can weaken signal.
Do you take part in public procurement?
Yes. We supply data sheets, manufacturer values and an itemised quote. As a VAT-registered company we issue an invoice.
Do you fit large glazing in gyms or atriums?
Yes, from a platform or scaffolding. The team is always two fitters certified for work at height.
How long does the film last?
Interior films commonly last 10 to 15 years or more. Exterior 3M Prestige lasts 10 to 15 years. We state the manufacturer’s warranty in the quote.
How is the film cleaned in a school?
Like a normal window, with a soft cloth and an ammonia-free cleaner. Don’t clean the glass for the first 30 days after fitting.
Do you also work for universities?
Yes. For example, we have worked on Comenius University buildings while they were in use. The approach is the same as for schools.
What do I need to prepare before the film is applied?
Clear access to the windows: leave roughly 1 metre of free space in front of and beside every window. Move wardrobes, beds, desks and plants away beforehand, clear the window sills, pull curtains aside and raise interior blinds. If something heavy cannot be moved, tell us in advance and we will plan around it.
Related services
-
Safety films
Broken glass holds together. Protects against break-ins and shards, EN 12600 and EN 356 classes.
Learn more -
Businesses and public buildings
Schools, hospitals, public offices, hotels, industry and energy.
Learn more -
Overheating offices and buildings
What the regulation says, why buildings overheat and what helps.
Learn more

Send us a photo of your window or car. We’ll prepare a quote as soon as possible.
A few details and a phone photo are enough. We’ll e-mail you a quote as soon as possible.